Happy to answer questions as I'm sure I left a few things out - there were a lot of one-off fabrications for this build.
2019 Nardo RS3, 24k miles - built by Ken Brown @ Cutaway Creations
Syvecs tuned by Wayne Potts @ ISC Tuning - 6 switchable maps via cruise control stalk / rolling antilag / flex fueling
STM 1000hp intercooler
Eventuri intake
Deka DQ500 - Race HD1300 clutch pack
Built motor - CP-Carrillo rods+pistons
Full frame XonaRotor 8264S turbo kit
ID1700cc injectors
Injector Dynamics fuel controller
Bull-X exhaust w/ fabricated external wastegate dump used >14psi
OMP WRC-R seats
StudioRSR roll cage, Nardo paintmatched
KW v3 coilovers tuned for traction
Plex ProSDM display with all Syvecs data
NitrousExpress setup, vent-mounted controls
SA Performance custom rear seat delete
Schroth Racing 5-pt harnesses
Odyssey Extreme PC925 Lightweight battery
Engine bay fire suppression w/ remote switch in dash
Brand new Girodisc rotors, front+rear
Don Octane billet manifold
Don Octane billet oil pan
Billet guibo
Billet driveshaft center support bearing
Upgraded trailing/lower control arms
R888R Proxes mounted on Apex wheels
Spare unused Hoosier DR2s mounted on Neuspeed wheels
Car has not been tracked since build was completed, but is every bit an 8 second car on proper tires/prepped surface. Dyno run was on a 150 shot, current setup is built to handle 200.
Title is in-hand and car is located in Charles Town, WV.
$79,000 obo.
Reply With Quote
Bookmarks