Audizine - An Automotive Enthusiast Community

Results 1 to 10 of 10
  1. #1
    Senior Member Three Rings
    Join Date
    Mar 20 2018
    AZ Member #
    415804
    Location
    Hanover, Maryland

    New North America S6/s7 record: 0-60, 1/4 & 60-130

    Guest-only advertisement. Register or Log In now!
    North America S6/S7 Record pass?0-60, 1/4 and 60-130? I think so!
    🙌🏾🙌🏾🏁🏁🚀🚀

    Spinnin, uphill and off the shoulder lol I think I ran over a barbie as I crossed over to the highway side lol

    We are only half way done tuning as I have only had this setup for 1 week and due to iat, I am losing power up top. Meth on the way!

    I was forced to run a full tank of gas because too many g forces for full pump/tank on half full. I couldn't even get out of first gear really, so this added weight def hurt me.

    With a good launch, I'd expect a 10.2
    With a few revisions, 4 bar map sensor, meth and proper start, I'm shooting for a 9.9

    Fuel e60
    Tire pressure 38 psi but will do try 30 psi so that I can hook this time!

    A special thanks to YanaVency Raychinovi for the tuning aka madness Motorsports, John Banks aka Dynospectrum for the base file and back end support from day 1! Mirza Mrkulic aka Boosted Euro for the strong TCU tune!

    Also thanks to John Rapkoch as he advised that I am running too much tire pressure in rear 😭

    2016 audi s6
    3" Custom downpipes with GESI highflow cats
    MercRacing heat exchanger w/ cwa100 pump and divorced cooling
    Custom exhaust
    20x9 with fk510 tire
    Srm inlets
    E60 fuel
    Dynospectrum custom tune by Vency at Madness Motorsports
    Ts1 turbos
    Car is full weight and full tank of gas
    Attached Images
    Last edited by TruS4; 05-10-2020 at 04:25 AM.

  2. #2
    Senior Member Two Rings
    Join Date
    Sep 28 2017
    AZ Member #
    407615
    Location
    Attleboro

    Very nice!

    Sent from my SM-N975U using Audizine mobile app

  3. #3
    Veteran Member Three Rings Stazi's Avatar
    Join Date
    Aug 27 2019
    AZ Member #
    516771
    My Garage
    2012 Audi A4 S-Line, 2019 Jeep Grand Cherokee Altitude 4x4, 2017 Moomba Craz
    Location
    Michigan

    Hauling ass!


    Sent from my iPad using Tapatalk
    2012 Audi A4 2.0T S-Line
    K04 // IE Stage 3 K04 tune // USP HFC // Becker Cat-back // ECS Intake Pipe (w/modded airbox + K&N) // ECS Luft-technik FMIC Intercooler and pipe kit // GFB VTA // RS mesh grille // CF M4 style spoiler // ST rear sway bar.

  4. #4
    Established Member Two Rings ndabunka's Avatar
    Join Date
    Mar 10 2009
    AZ Member #
    39694
    Location
    Charlotte, NC

    Why aren't you running drag radials IF your objective is drag strip times?
    '16 S7 Daytona, Black Interior w/Options: HUD, LED Headlights, S7 Sport Pkg, Driver Assistance, Black Optics, 20" 5-double-spoke wheels, Comfort Seating, Carbon Atlas Inlay, Power/Soft-closing doors, Audi Door Beam "Rings", Premium S7 Logo Mats, Brilliant Black Quattro Decal lower rear door panel

  5. #5
    Senior Member Three Rings
    Join Date
    Mar 20 2018
    AZ Member #
    415804
    Location
    Hanover, Maryland

    Quote Originally Posted by ndabunka View Post
    Why aren't you running drag radials IF your objective is drag strip times?
    Being you don't have any dragy times to show at all... you don't really understand the process most likely...

    Secondly if you did understand...you would know that tire pressure will likely get me where I want to go...

    Third, how do you know my objective? This is a car that I daily drive..I want to do this all on a setup that I'll have every day, which includes car beingfull weight...not some glamour run then I'd never do again...

    - - - Updated - - -

    Quote Originally Posted by Stazi View Post
    Hauling ass!


    Sent from my iPad using Tapatalk
    Thx for the support! Looking forward to the next round of mods that will really open her up!

  6. #6
    Veteran Member Four Rings
    Join Date
    Jan 26 2015
    AZ Member #
    311551
    My Garage
    2017 XC90, a workbench
    Location
    CO

    Ya that’s looking good!! Get that 60 ft down to 1.5-1.6 and it could get low 10’s for sure.


    Sent from my iPhone using Tapatalk
    -------
    2018 S6 - stock for now
    2014 S6 - Stage 3 - Gone
    2013 S4 - Dual Pulley e85 - Gone

  7. #7
    Established Member Two Rings ndabunka's Avatar
    Join Date
    Mar 10 2009
    AZ Member #
    39694
    Location
    Charlotte, NC

    Quote Originally Posted by TruS4 View Post
    Being you don't have any dragy times to show at all... you don't really understand the process most likely...

    Secondly if you did understand...you would know that tire pressure will likely get me where I want to go...

    Third, how do you know my objective? This is a car that I daily drive..I want to do this all on a setup that I'll have every day, which includes car beingfull weight...not some glamour run then I'd never do again...

    - - - Updated - - -
    A 9 second S7...You are funny!
    1. One need not post drag slips to have knowledge
    2. Not really but if your limited then it's a compromise that may work for you
    3. Your objective is in your TITLE of this thread
    Good luck Bunka Out!
    '16 S7 Daytona, Black Interior w/Options: HUD, LED Headlights, S7 Sport Pkg, Driver Assistance, Black Optics, 20" 5-double-spoke wheels, Comfort Seating, Carbon Atlas Inlay, Power/Soft-closing doors, Audi Door Beam "Rings", Premium S7 Logo Mats, Brilliant Black Quattro Decal lower rear door panel

  8. #8
    Senior Member Three Rings
    Join Date
    Mar 20 2018
    AZ Member #
    415804
    Location
    Hanover, Maryland

    Quote Originally Posted by Hofahome View Post
    Ya that’s looking good!! Get that 60 ft down to 1.5-1.6 and it could get low 10’s for sure.


    Sent from my iPhone using Tapatalk
    🙌🏾🙌🏾🏁🏁💪🏾💪🏾

    - - - Updated - - -

    Quote Originally Posted by ndabunka View Post
    A 9 second S7...You are funny!
    1. One need not post drag slips to have knowledge
    2. Not really but if your limited then it's a compromise that may work for you
    3. Your objective is in your TITLE of this thread
    Good luck Bunka Out!
    No my title speaks to what I already accomplished lol

  9. #9
    Veteran Member Four Rings
    Join Date
    Jan 26 2015
    AZ Member #
    311551
    My Garage
    2017 XC90, a workbench
    Location
    CO

    Quote Originally Posted by ndabunka View Post
    A 9 second S7...You are funny!
    1. One need not post drag slips to have knowledge
    2. Not really but if your limited then it's a compromise that may work for you
    3. Your objective is in your TITLE of this thread
    Good luck Bunka Out!
    Why is a 9 sec S7 funny? Shit even stock blower stock block S4’s can run mid 10’s without nitrous


    Sent from my iPhone using Tapatalk
    -------
    2018 S6 - stock for now
    2014 S6 - Stage 3 - Gone
    2013 S4 - Dual Pulley e85 - Gone

  10. #10
    Veteran Member Three Rings MolonLabe300's Avatar
    Join Date
    Aug 16 2017
    AZ Member #
    405117
    Location
    Chattanooga

    That's what I was thinking, the C7 platform has the good possibility of being in the 9's this year.
    Quote Originally Posted by Hofahome View Post
    Why is a 9 sec S7 funny? Shit even stock blower stock block S4’s can run mid 10’s without nitrous


    Sent from my iPhone using Tapatalk
    Sent from my Pixel 2 XL using Audizine mobile app
    13 S6 SRM +4mm, Flex Fuel lines with ethanol sensor, Milltek turbo back, SRM Red Long intakes, NGK race plugs, AMG coolant pump. Merc HX, DS1 OTS stage 4, SRM TCU

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


    © 2001-2025 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.