Audizine - An Automotive Enthusiast Community

Results 1 to 4 of 4
  1. 03-13-2010 09:41 PM #1
    Moonz_A6
    Moonz_A6 is offline
    Established Member Two Rings Moonz_A6's Avatar
    Join Date
    Jun 22 2008
    AZ Member #
    30179
    Location
    Mesa, AZ

    engine speed sensor location and replacement.

    Guest-only advertisement. Register or Log In now!
    Hi guys.. I know I'm in the wrong forum but since the S4 and my 2001 a6 2.7t 6M share the same engine. I was hoping some of you guys would help me. I need to change my engine speed sensor and can't find a DYI on this nor a diagram of the location. Any Help will be greatly appreciated.
    GIAC Stage 3- flash, APR BiPipe. K04's, H&R Race Springs w/ Bilstein Sports. AWE DTS. Apikol Poly Rear Carrier mount bushings. Apikol Poly Diff mount. 3" Downpipes. Testpipes "NO CATS". 2.5 piping and Borla XL mufflers w/ 3.5 Tips. 2002 A6 rear Bumper Cover. USP Steel Braided Clutch Line and Metal Slave cylinder. RS4 Pressure Plate with 6 Puck Carbon Kevlar unsprung clutch disk & Metal face Throwout Bearing. 034 Poly Snub Mount & Cage. Rs4 Engine & Apikol Tranny Mounts. Allroad headlights.
    Reply With Quote Reply With Quote  
  2. 03-13-2010 10:16 PM #2
    JaiMoney
    JaiMoney is offline
    Active Member Two Rings
    Join Date
    Jun 20 2007
    AZ Member #
    18949
    Location
    Colorado

    On the driver side trans housing. Find the connector at the top behind the coolant tank (if its the same as an s4) and follow it down. One bolt holding it in. If I remember right it's right above where the half shaft bolts on.
    Reply With Quote Reply With Quote  
  3. 03-13-2010 10:23 PM #3
    Trigger Happy
    Trigger Happy is offline
    Veteran Member Four Rings Trigger Happy's Avatar
    Join Date
    Jun 17 2008
    AZ Member #
    30034
    My Garage
    2K S4
    Location
    Rockville, MD

    Here you go
    http://www.audizine.com/forum/showth...=1#post2941585
    "Clearly, a liger is not as practical as a Katana. S4s can't carry ligers. fucking 500lb cat in my backseat using my alcantara as a scratch post for its HUGE FUCKING CLAWS? I dont' think so bro"

    Understeer is when you hit the wall with the front of the car and oversteer is when you hit the wall with the rear of the car. Horsepower is how fast you hit the wall and torque is how far you take the wall with you.
    Reply With Quote Reply With Quote  
  4. 03-14-2010 08:11 PM #4
    Moonz_A6
    Moonz_A6 is offline
    Established Member Two Rings Moonz_A6's Avatar
    Join Date
    Jun 22 2008
    AZ Member #
    30179
    Location
    Mesa, AZ

    Thank you both for the responses. I really must say. Going to the gym and working on Audi's don't work well together. My arm got stuck a few times changing that damn thing. LOL! but I got it done. Thanks for the help guys.
    GIAC Stage 3- flash, APR BiPipe. K04's, H&R Race Springs w/ Bilstein Sports. AWE DTS. Apikol Poly Rear Carrier mount bushings. Apikol Poly Diff mount. 3" Downpipes. Testpipes "NO CATS". 2.5 piping and Borla XL mufflers w/ 3.5 Tips. 2002 A6 rear Bumper Cover. USP Steel Braided Clutch Line and Metal Slave cylinder. RS4 Pressure Plate with 6 Puck Carbon Kevlar unsprung clutch disk & Metal face Throwout Bearing. 034 Poly Snub Mount & Cage. Rs4 Engine & Apikol Tranny Mounts. Allroad headlights.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules



    © 2001-2025 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.