vtraudt
02-13-2017, 03:06 PM
I dropped off a pair of 2.7T APB heads at the engine shop.
They came back and said that the height spec (not sure of correct term) call for min of 5.2260 and actual is 5.220.
I have not had other shops mention this specification (not sure if they are aware of it or even check it)
They are not sure if this is sufficient.
Does anybody have experience? Should I tell them to go ahead, machine and rebuild (valve job, etc)?
They came back and said that the height spec (not sure of correct term) call for min of 5.2260 and actual is 5.220.
I have not had other shops mention this specification (not sure if they are aware of it or even check it)
They are not sure if this is sufficient.
Does anybody have experience? Should I tell them to go ahead, machine and rebuild (valve job, etc)?